Work modes
21
Master spindle control
Vary the speed override from the operator panel.
With the operator panel, it is possible to change the percentage
of spindle speed using the jog keyboard or a switch (depending
on model).
Keyboard.
Start the spindle counterclockwise (same as the
function M03) at the active speed.
Start the spindle counterclockwise (same as the
function M04) at the active speed.
Stop the spindle (same as M05 function).
Orient the spindle (same as M19 function).
Keyboard.
JOG keypad.
Increases or decreases the percentage of spindle
speed. The maximum and minimum values as well as
the incremental step are set by the OEM, the typical
values being a variation between 50% and 120% with
a 5% step.
Switch.
It sets the percentage of turning
speed to be applied. The
maximum and minimum values, as
well as the incremental step are set
by the OEM (typical values being a
variation between 50% and 120%,
with a 5% step).
200
190
180
170
160
150
140
130
120
110
100
90
80
70
60
50
40
30
20
10
4
2
0
SPEED
To Next Page
Loading...
