Work modes
33
Repositioning the axes.
Once the block search is finished, the CNC will show the
axes that are out of position. The axes may be
repositioned individually or several at the same time in
one of the following ways:
• Manual repositioning of axes. Jog the axes with the
handwheels or with the JOG keys. The movement is
limited by the repositioning end point and the
corresponding software limit.
• Automatic repositioning of axes. Select the axes with
the relevant softkey and press [START].
Repositioning may be interrupted (using the [STOP]
key) to select other axes.
Changing the machining conditions.
After positioning the axes and before resuming
execution, tool inspection may be accessed to change
the machining conditions. In tool inspection, it is
possible to change the feedrate and the spindle speed,
execute blocks in MDI/MDA mode as well as activate M
and H functions.
To Next Page
Loading...
