ISO canned cycles (M)
66
G82
* * Drilling canned cycle with a variable peck.
G82 [Z] I [D] B [H] [C] [J] [K] [R] [L] [A]
Z: Reference plane
I: Drilling depth
D: Distance between the reference plane and the
part surface (default = 0)
B: Drilling peck (step)
H: Rapid feedrate withdrawal (J>0) or
withdrawal coordinate (J=0) distance after
each drilling peck
C: Approach coordinate
J: Number of drilling steps for rapid feedrate
withdrawal (G0). J0: it returns to the
coordinate value H after each step; J1: it
returns to the coordinate value Z; J>1: after
each step, it returns the distance indicated by
H and every J step to the reference plane Z.
K: Dwell in seconds at the bottom of the hole
R: Factor that increases or reduces the drilling
peck (step) B
L: Minimum value allowed for the drilling peck
A: Spindle behavior when entering and exiting
the hole.
A0: The tool enters the hole and exits while
turning (default value)
A1: The tool goes into the hole turning and
comes out stopped
Function MDVMeaning
To Next Page
Loading...
