10
The refrigerator does not operate
The refrigerator or freezer is not
very cold
The refrigerator vibrates
The compressor runs constantly
Drops of water or ice on the
refrigerator back wall
• It is not plugged in
• There is no electrical current to
the receptacle because the fuse
has blown or the circuit breaker
is tripped
• The connection controls are
not on
• Temperature selection is set too
high
• The door is not properly closed
or is opened very frequently
• The space between the
refrigerator and fl oor or the top of
the refrigerator has been covered
• The refrigerator is exposed to
direct sunlight or a heat source
• A large amount of food has been
introduced
• The refrigerator is incorrectly
leveled
• The doors are not properly
closed
• The doors are opened often
• The food was introduced recently
• Temperature selection is in the
high position
• Moisture condensing on the
evaporator
• Plug in
• Change the fuse or reset the
circuit breaker.
• Switch the controls on
• Reduce the set temperature as
indicated in section 2.3
• Ensure that the door does not
remain open too long
• Keep these areas free as
described in the Installation
section in this manual
• Relocate the refrigerator or
protect it from these heat
sources
• Refer to sections 2.4 and 2.5 for
tips on maintaining temperatures
in these cases
• Level the refrigerator correctly,
with the leveller bases
• Close the doors properly
• Avoid opening the doors
frequently
• Wait for the appliance to return
to normal
• Set the temperature switch to
less cold
• Do not worry: this is completely
normal
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Water in the bottom of the
refrigerator
• Drain ducting blocked • Clean the drain ducting .
Remove anything that blocks
the duct.
english