ELECTRONIC ADJUSTMENT
If there is a salt regulator inside
your dishwasher on the right,
e.g. Mod. C or Mod. D, you
should adjust the salt from the
control panel with the
dishwasher running pressing
the on/off button but with no
programmes running.
Identify your dishwasher:
Type A or Type B.
Type A models (display
models): Press the
button and hold it down
for 3 seconds. A number
with the letter L before it
(L2) will appear on the
display. Press the
button again to select the
salt regulator position
required.
a
b
Type A: display models
Type B: pilot light models
Mix
PROG
STOP
50º
55º
50º
65º
70º
PROG
L2
a
Display models
b
REGULATOR Model C
REGULATOR Model D
MANUAL REGULATION
If there is a salt regulator like the
one shown in the photographs
(Mod. A-B) inside your dishwasher
on the right-hand side, turn it to the
number that corr
esponds to the
hardness of the water in your area
(see table).
To turn it to the correct position, use
a coin (Mod. A) or a screwdriver
(Mod. B).
Controlling the salt level
Depending on the model, dishwashers
will have a manual or electronic salt level
contr
ol.
This simple adjustment of your dishwasher is vital
for its correct functioning. Do not ignore it.
REGULATOR Model B
REGULATOR Model A
If you wish to use combined detergent tablets (3-in-1, 4-in-1), turn the dial to the
corresponding test result number. If you use traditional detergents after this, turn the
dial to the test result number again.
To Next Page
Loading...
