When do I need to add rinse-aid?
The dishwasher itself will inform you of
when the rinse aid needs refilling.
A pilot light on the design panel will
come on when a refill is necessary.
PILOT LIGHT
The rinse-aid helps drying and
prevents drops of water from clinging
to utensils after washing. The rinse-aid
container is located on the inside of
the door, next to the detergent
container.
It has a 4-position dispenser for
adjusting the amount of rinse-aid to
the water quality (the dispenser is set
at position 2 at the factory).
If you notice drops of water on utensils,
increase the position of the rinse-aid
dispenser. If the utensils have white or
sticky lines, lower the position.
RINSE-AID CONTAINER
DISPENSER
a
Once the level of the
dispenser has been
set, fill the container
to the top, but do not
overfill it. If this
occurs, clean the
spillage with a cloth.
a
A greater amount of rinse-aid does
not necessarily mean better
results. In fact, too much rinse-aid
can lead to water marks.
IMPORTANT
When do I need to add salt?
A pilot light will come on to show when
more salt needs to be added.
PILOT LIGHT
Important:
If your dishwasher does not
have a display or pilot light, you should
periodically refill the salt that has been
used (about every 20 washes for
medium-hard water).
You should not use salt if your
dishwasher does not need it. In
this case, the pilot light will remain
on at all times.
IMPORTANT
When the salt container needs filling,
you should always do it before a wash
and not afterwards.
d
c
Stir with a spoon.
Close the lid tight and clean the salt
around the container.
c
d
To Next Page
Loading...
