Fagor LVC-12 - Installation; Installation Diagrams; Appliance Positioning; Water Connection

16
1.- INSTALLATION
1.1.- Installation diagrams
See Fig.1
1.2.- Positioning
Level and adjust the height of the appliance. (Fig. 2)
1.3.- Water connection
− To be done as shown in figures 3 or 4.
− Dynamic pressure necessary during rinsing: 2 - 4 Kg./cm
2
(3.5 ÷ 5 Kg./cm
2
).
− With mains pressures of less than 2 Kg/cm
2
(3.5 Kg./cm
2
)., install an electric pressure
pump. (Fig.4).
1.4.- Drainage
a) Fix the drain hose as shown in Fig.5.
b) Fit a siphon pipe to prevent bad smells.
1.5.- Electrical connection
− For access to the connection strip (R), (Fig. 6 and Fig. 1), remove the cover (T) and the
rear panel (P). Connect the strip as shown in figure 6. Fix the sheathed cable in (E), leave
enough cable to remove the electrical panel from the front.
− Fit a general switch (I) independent of the appliance with a distance between contacts
equal to or more than 3 mm.
− The machine must be earthed.
1.6.- Technical specifications
Power(Kw)
MODEL
H. element
Max
Water inlet
pressure
Supply
voltage
Drum
Tub
absorb.
Basket
(mm)
Cycle
duration
Min.
Tub
capacity
(l)
Rinse water
consumpt
(l)
Net
weig
(Kg)
LVR-10
LVC-12
1 34
LVC-15
2÷4 Kg/cm²
(28÷56psi)
LVC-15D
3.5÷5
Kg/cm²
(42÷70psi)
2,4 2,66 Ø350x350 11 2
36
LVC-21
2÷4 Kg/cm²
(28÷56psi
LVC-21D
3.5÷5
Kg/cm²
(42÷70psi)
2 MAX.
(Adjustable)
39
LVC-21B
2÷4 Kg/cm²
(28÷56psi
220-240V - 1N
(50/60Hz.)
2,8
2
3,06
400x400
2
(Fixed)
15 2,5
412