13
Refrigerator Leveling &
Door Adjustment
The refrigerator must be leveled in order to maintain optimal
performance and desirable front appearance.
(You will be able to tell the refrigerator is uneven because
the freezer and refrigerator doors look unbalanced.
In case freezer door is lower than
refrigerator door...
Insert a screw driver (flat tip)
into a groove of the left wheel
(bottom of freezer) and turn
it clockwise until the door is
balanced. (clockwise to raise
freezer door; counterclockwise
to lower)
Ɠ If the freezer door is not balanced by step 1, then
follow the next steps.
Open the doors, unscrew the
front cover and remove, if it is
attached.
.
In case refrigerator door is lower than
freezer door...
Insert a screw driver (flat tip)
into a groove of the right wheel
(bottom of refrigerator) and
turn it clockwise until the door
is balanced. (clockwise to raise
refrigerator door ;
counterclockwise to lower)
Ɠ If the refrigerator door is not balanced by step 1, then
follow the next steps.
Insert a spanner (A part) into the hinge nut (1 part) and
unscrew the nut by turning clockwise.
Insert a spanner (B part) into the hinge nut (2 part) and
turn counter-clockwise to highten the door.
Front Cover
After installation and/or door leveling, fasten front cover with
screws. (Remove the screws on the front bottom panel first.
Click and screw the cover)
Caution
ƗThe front of refrigerator needs to be just a little
higher than the back for easy door closing. However,
if the wheel is raised too much for door balance,
i.e. the front of refrigerator is much higher than
the back, it can be difficult to open the door.
Water filter (Dispenser models only)
1. Remove the locking cap for
installing the filter.
(The ice and water dispenser can
also be used without a water filter,
in which case the locking cap must
be used. )
2. Carefully turn the filter clockwise.
3. Change the filter at least every
6 months.
ٙ$1HZILOWHUFDQEHREWDLQHGIURP
an authorized aftersales service.
Caution
ƗMake sure to clean up any fallen water during the
filter installation.
1
1
2
3
2
4
3
If the door is aligned, fasten the nut (1) tightly with
turning.
Insert a spanner (Part A) into the hinge nut(1part) and
unscrew the nut by turning clockwise.
Insert a spanner (B part) into the hinge nut(2part)
and turn clockwise to lower the door
If the door is aligned, fasten the nut (1) tightly by turning
counter-clockwise.
4
5
To Next Page
Loading...
