5.2.2 Switching on the heating elements
• Press the power switch situated on the outside of the appliance.
• Rotate the “M” thermostat control clockwise to the machine connected position so that the light
L1 (green) comes on.
• Then, to turn the appliance on, turn the thermostat control clockwise to the required position,
according to the desired temperature.
• The light L2 (amber) lights up when the heating elements are operating.
• When the water in the vat reaches the selected temperature, the resistors (by means of the
thermostat) stop working and the L2 lamp (amber) turns off. Likewise, when the temperature
drops below the selected value, the heating elements start to operate, and the light L2 (amber)
comes on.
5.2.3 Switching off the heating elements
• Rotate the M thermostat control anticlockwise to the Off position , the light L1 (green) goes off.
5.2.4 Filling the tub
• The tilting bratt pan has a filler tap built into the tub, which is controlled by control A.
• To fill, turn control A to position .
5.2.5 Tub drainage
• Motorised versión:
o The tilting bratt pan has a motor for tilting the pan, activated using the buttons V.
• Manual versión:
o The tilting bratt pan has a wheel.
o To tilt the pan, turn the wheel clockwise.
o To lower the pan, turn the wheel anticlockwise.
5.3 Useful tips
Read the useful tips listed below carefully in order to get the most out of your tilting bratt pan.
5.3.1 Initial cleaning
To Next Page
Loading...
