FAIR srl - Via Lago di Costanza 24 - 36015 Schio - Vicenza - Italia - +39 0445 698 000 - export@fair-europe.com - www.fair-europe.com
Pag. 2
1. Turn on the stove for about 15 minutes to warm all of its parts.
2. Turn off the stove and wait for the shut-off phase to be completed before starting the disassembly.
3. Disconnect the power supply.
4. You must have the following materials before handling the stove:
Anti-scratch protection gloves
Powder mask
Ash aspirator, brush, screwdriver, rubber hammer, hex key and spatula
Any gaskets and replacement tubes
High temperature silicone 750°C or higher
5. Check the chimney, clean the T-fitting (if present),
inspect the entire section of the tube connecting
the stove to the chimney and the chimney itself.
6. Check if gaskets and any fittings / tubes are intact.
If damaged replace them.
7. Remove the top of the stove by unscrewing the 3
screws holding it secured, using hexagonal
wrench.
To Next Page
Loading...