FAIR srl - Via Lago di Costanza 24 - 36015 Schio - Vicenza - Italia - +39 0445 698 000 - export@fair-europe.com - www.fair-europe.com
Pag. 3
8. Remove the heat exchanger grille by unscrewing
the 4 star screws.
9. Remove the right and left flue gas inspection plates
by unscrewing hexagonal screws with hexagonal
or tube wrenches. Use a screwdriver, if necessary,
to remove the siliconized dowels.
10. To remove soot and scratches beat in the front
and top area with a rubber hammer or similar as
shown in the picture.
11. Insert a pipe cleaner inside of inspections to
precipitate the soot adhered to the smoke motor.
12. Use the ash aspirator with the 2 open inspection
doors.
To Next Page
Loading...