Falco VL35F230B - User Manual

Other manuals for Falco VL35F230B

Installation And Operating Instructions65 pages

Questions and Answers

D
Diane PriceJul 25, 2025
Why is my Falco Lifting Systems hydraulic system making abnormal sounds?
- X
  xchapmanJul 25, 2025
  Abnormal sounds in the Falco Lifting Systems hydraulic system can occur if the oil filter is clogged, so you should clean it. Another cause may be air in the system; in that case, lift the collar to its maximum height, hold for 2-3 seconds, and then lower it. Repeat this process 2-3 times. Also, check if the surface between the sliding blocks and columns needs lubrication and add it if necessary.
R
Robert BarrettJul 31, 2025
What to do if the Falco Lifting Systems generator does not work?
- F
  Francisco BradshawJul 31, 2025
  If the generator of your Falco Lifting Systems does not work, the power source or power equipment may be malfunctioning. Check the power source, other electrical components, and fuses.
T
Teresa JosephAug 6, 2025
Why does the collar automatically lower in working mode on my Falco VL35F230B Lifting Systems?
- S
  Samuel MccormickAug 6, 2025
  If the collar automatically lowers during operation of your Falco Lifting Systems, it could be due to several reasons. The pistons might have lost effectiveness, requiring you to fix them. Alternatively, the pipes could be leaking oil, in which case you should change the seals and tighten the nuts on the connection. Lastly, the seals on the hydraulic cylinders may have lost effectiveness, so you should replace them.
K
kristenmcphersonAug 12, 2025
What to do if the main and supplementary sliding tables don’t move synchronous in Falco VL35F230B?
- J
  James BeardAug 13, 2025
  If the main and supplementary sliding tables of your Falco Lifting Systems aren’t moving synchronously, it's likely that the equilibrium cables have stretched out after use and lost their tension. You should adjust the nut on the steel cables to add tension.
C
Christopher OchoaAug 18, 2025
How to fix collar creeping when raising and lowering Falco VL35F230B?
- C
  Chase SandersAug 18, 2025
  Collar creeping during raising and lowering of your Falco Lifting Systems can occur if the space between the sliding blocks and the columns is too narrow. To resolve this, select sliding blocks that will leave a gap between 1.5 and 2.5mm between the blocks and column.