14、Do I have to wear goggles?
CR-Laser Falcon adopts the design of shading and eye protection, and integrates the MEMS
attitude sensor. The laser module will stop working when the machine turns on it side abnormally.
Even so, we still recommend that you wear goggles during working.
15、During off-line working, the laser module “HOME” abnormally and makes the sound
of hitting the profile continuously. How to deal with it?
It is due to the limited switch cannot be closed normally. Ensure that：
1. X direction：When the laser module moves to the end of the left side, the limited switch of X-axis
can be closed normally；
2.Y direction：When the laser module moves to the end of the control box, the limited switch
of Y-axis can be closed normally；
If the limited switches cannot be closed, check whether the wire is obstructing the movement
of the laser module and the X-axis assembly first. Then reinstall the X-axis assembly to make it
parallel to the front and rear X-axis profiles.
16、What will cause if the belt too loose or too tight?
The engraved graphics will be deformed and dislocated obviously：like a circle changes into an
ellipse.
Engraving or Cutting
1、What material can I engrave or cut?
To Next Page
Loading...