33
Putting the vehicle into operation
EN
If you do not use any Master (Art. 161354) the vehicle will move using
“analog control”. After being switched on, it will try to come into radio
contact with a Master for about five minutes before switching off its
radio and ultrasonic signals. In such a case radio and ultrasonic signals
will not be reactivated until the vehicle is switched off and on again.
If the vehicle is not within the radio control area of a Car System Digital
Master, it will behave like an analog vehicle and can be used on analog
Car System installations without any difficulty.
X
Put the vehicle onto the roadway in such a way that the steering rod-
comes in contact with the special contact wire built into the roadway.
X
Let the vehicle go.
To Next Page
Loading...
Need help?
General