35
Activating special functions
EN
Key Description
»F2« Front warning lights/Front flashing lights (only on vehicles
with special signalling equipment)
»F3« Siren (only on vehicles with special signalling equipment)
»F4« Horn
»F5« Turn signal left
»F6« Turn signal right
»F7« Hazard warning signal flashers
»F8« High beam
»F9« Flick of headlamp beam
Tab. 1: Activating various functions
NOTE:
Functions F5 to F9 can be activated only through a digital center that
has been connected to the charging unit.
Functions can be activated in any order and any possible combination.
Functions that have been modified within the vehicle by means of a wire
will remain stored even after switching the vehicle off.
Functions that have been modified within the vehicle by means of radio
control will not remain stored after switching the vehicle off.
How to activate functions by wireless control on driving mode
All functions of the vehicle can be modified by radio control during opera-
tion via the Car System Digital software, when using a personal computer
connected to the Car System Digital Master. You may either click on the
relevant symbol in the menu, or use a command sent by an automatic pro-
cess, or even use speech control. All functions can also be activated via a
digital center connected to the Car System Digital Master (see the instruc-
tion manual of your digital center).
The vehicle can be made to slow down using a stop point with reversed
polarity installed in the roadway (see page 42). As soon as the magnetic
field sensor built into the vehicle detects a south magnetic field, the speed
will be reduced to slow speed. This state will be maintained up to the next
full stop point.
To Next Page
Loading...
Need help?
General