To Next Page

To Previous Page

ENGLISH

MAINTENANCE

Before cleaning or carrying out maintenance operations, disconnect the equipment by removing the plug or switching o the

main switch.

Regular maintenance guarantees proper operation and good performance over time.

Special attention is to be paid to the metal anti-grease lters and active carbon lters. In fact, frequent cleaning of the lters and their supports

ensures that no grease is accumulated on the hood, which is dangerous and can cause res.

EXTERNAL CLEANING

You are advised to clean the external surfaces of the hood at least once every 15 days to prevent oily substances and grease from sticking to them.To

clean the brushed stainless steel hood, the Manufacturer recommends using "Magic Steel" wipes. Alternatively, it can be cleaned using a damp cloth,

slightly moistened with neutral, liquid detergent or denatured alcohol. Finish o cleaning by rinsing well and drying with soft cloths.

Do not use too much water next to the push button control panel and lighting devices in order to prevent humidity from reach-

ing electronic parts.

You must not use detergents containing abrasive, acid or corrosive substances or abrasive cloths: a direct consequence of not

complying with these warnings will result in irreversible deterioration of the hood's surface.

The glass panels can only be cleaned with specic, non-corrosive or non-abrasive detergents using a soft cloth.

The Manufacturer declines all responsibility for failure to comply with these instructions.

CLEANING OF INTERNAL PARTS

It is forbidden to clean electrical parts, or parts related to the motor inside the hood, with liquids or solvents.

Do not use abrasive products. All these operations are to be carried out after having disconnected the equipment from the

electrical mains power supply.

METAL ANTIGREASE FILTERS

The metal anti-grease lters are there to contain suspended grease particles: deposited on the lters, these feed on any

ames released when cooking, generate unpleasant odours, and compromise the passage of air, thus reducing suction

performance of the hood.

For this reason, it is advised to frequently wash the metal lters (at least once a month) leaving them to soak in boiling

water and dish washing liquid for 1 hour, taking care not to bend them. Do not use corrosive, acid or alkaline detergents.

Rinse them well and wait for them to be completely dry before reassembling them.

Washing in a dishwasher is permitted, however, it may cause the lter material to darken: to reduce the possibility of this

problem from happening, use low-temperature washes (55°C max.).

Use the handle to take out the metal anti-grease lters (see instructions O on page 9). Carry out operations in reverse order to insert

them.

ACTIVE CARBON FILTERS

Active carbon lters have the function of retaining odours in the air ow passing through them. The air, puried by running

many times through the lter, is recirculated into the kitchen.

Active carbon lters cannot be washed and are to be immediately replaced every 3-4 months (depending on the fre-

quency of use of the hood).

Dispose of the active carbon lters in compliance with the regulations in force in the country of use.

To change active carbon lters, take out the metal anti-grease lters (see instructions O on page 9) and follow the instructions P on

page 9.

DISPOSAL AFTER END OF USEFUL LIFE

This symbol on products and/or in accompanying documents means that electrical and electronic products used must not be disposed of with general do-

mestic waste. For personal treatment, recovery and recycling, you are kindly asked to take these products to designated waste collection points where they

will be accepted freely. Alternatively, in other countries, it is possible to take products back to the local dealer and purchase a new similar product. Proper

disposal of these products contributes to saving valuable resources and avoid potential negative eects on personal health and the environment, which

may be caused by inappropriate disposal of waste. You are kindly asked to contact your local authorities for further information regarding the designated

waste collection points nearest to you. Penalties for improper disposal of such waste can be applied in compliance with national regulations.

INFORMATION REGARDING DISPOSAL IN EU COUNTRIES

The EU Directive with regard to WEEE has been implemented dierently by each nation, therefore, should you wish to dispose of this equipment, we advise

you to contact the local authorities or the dealer to ask for the correct method of disposal.

INFORMATION REGARDING DISPOSAL IN OTHER NONEU COUNTRIES.

This symbol is only valid in the European Union: if you wish to dispose of this product in other countries, we advise you to contact your local authorities or

dealer to ask for the proper method of disposal.