Cold Water Rheology Instruction Manual
372144 Revision D, May 2012 9
4 Equipment Setup
Set up the bath on a stable surface away from flammable or combustible materials.
Connect the tubing on the circulating bath to the insulated cup. The bath has
labeled connections – in and out. The quick disconnects ensure proper connection.
Be certain that the tubing and cup are always covered with the insulating material.
Make certain that the Model 35 operates properly with the insulated cup in place.
Each unit uses 50/60 Hz. Make sure that the unit –115 or 230
VAC is rated for the power source.
To Next Page
Loading...