Fantec RayPlay U3 - HDD Format

EN -13-
Nr.
Description
1
Remove the 2 screws from the rear panel
2
Remove the 4 screws from bottom plate
3
Remove the 4 screws from the HDD tray
4
Put the HDD onto the tray
5
Fix the HDD at the tray
6
Fix the HDD incl. Tray to the bottom plate
7
Connect the HDD with the SATA data cable and with
the power cable and then fix the bottom plate at the
enclosure
8
Fix the 2 screw at the rear panel
3.2 HDD Format
For users who wish to install a new SATA HDD into the player, please
refer to the following procedures to format the hard disk on the player
before usage.
Note: This page can be also accessed via Setup->System->Format
menu.
- Step 1: Select Internal HDD on the Warning page, press ENTER
to confirm.
- Step 2: Select OK, press ENTER, and then press Format to start
the formatting procedure.
The formatting procedure will be finished within a few minutes. Press
OK and then you can use the hard disk properly on the player.
Note: HDD format will remove all data stored on the hard disk drive.
Please take care and backup your data in advance!