EasyManua.ls Logo

Fantic Motor TZ 125 2011 - User Manual

Fantic Motor TZ 125 2011
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...

Questions and Answers

  • J
    johnsonwilliamSep 9, 2025
    Why is the shock absorber on my Fantic Motor TZ 125 2011 Motorcycle set too soft?
    • T
      Todd WheelerSep 9, 2025
      If the shock absorber on your Fantic Motor Motorcycle is set too soft, it could be due to insufficient front fork oil. Fill with fork oil until reaching the correct oil level. Another cause might be front fork oil viscosity too low, drain fork oil and fill with correct fork oil viscosity. Also, tire air pressure too low can cause this, so check tire air pressure. Finally, incorrect rear shock absorber adjustment can be the problem, so adjust the rear shock absorber.
  • T
    troy02Aug 23, 2025
    Why does my Fantic Motor Motorcycle engine lack power or have poor acceleration?
    • D
      Dave WileyAug 23, 2025
      If your Fantic Motor Motorcycle lacks power or has poor acceleration, it could be due to a defective fuel supply. Try cleaning the fuel system and verifying its operation. Another cause might be a dirty air cleaner, so clean or replace it and verify its operation. Also, check for a leaking or deteriorated exhaust system and replace the muffler fiberglass packing if needed. Other potential issues include dirty carburetor jets (disassemble the carburetor and clean all jets), worn or damaged crankshaft bearings (replace them), or a slipping clutch (verify the clutch operation).
  • J
    Jody WatsonAug 25, 2025
    What to do if Fantic Motor TZ 125 2011 engine cranks but then stops?
    • K
      Karina RodriguezAug 25, 2025
      If your Fantic Motor Motorcycle engine cranks but then stops, it might be due to an incorrect air supply. Try closing the starter, cleaning the fuel tank air vent, and adjusting the air cleaner duct. Another possible cause is that the fuel tank is empty, so fill it up.
  • C
    Christina MartinAug 26, 2025
    Why is my Fantic Motor TZ 125 2011 engine overheating?
    • S
      Stephanie Booker MDAug 27, 2025
      If your Fantic Motor Motorcycle engine is overheating, it could be due to insufficient cooling liquid in the circuit. Fill up the cooling liquid and verify the refrigeration system's watertightness. Another cause could be a dirty or partially restricted radiator, so clean the radiator fins or replace the radiator.
  • E
    Emily OsbornAug 27, 2025
    Why does my Fantic Motor TZ 125 2011 Motorcycle engine operate irregularly?
    • A
      Angela JacksonAug 28, 2025
      If your Fantic Motor Motorcycle engine operates irregularly, the spark plug might be dirty or misadjusted. Verify its condition, clean it, tighten, or replace it. Also, check the spark plug cap for poor contact or a loose cable and replace the cap if deteriorated. Another potential cause is a damaged ignition rotor, which would need replacement. Finally, water in the fuel can cause this issue, so drain the fuel tank and fill it with new fuel.
  • B
    Brittany MorganAug 29, 2025
    What causes detonations from the exhaust pipe in my Fantic Motor TZ 125 2011 Motorcycle?
    • J
      Jesse LopezAug 29, 2025
      If you are experiencing detonations from the exhaust pipe of your Fantic Motor Motorcycle, it could be due to carbon build-up in the combustion chamber, which requires cleaning. Another cause might be incorrect octane or poor quality gasoline. In this case, drain all the gasoline and fill up with a higher octane fuel. A damaged spark plug or one with incorrect specifications can also cause this, so replace it with a new one of the correct type. Finally, check for deteriorated exhaust system gaskets and replace them if necessary.
  • P
    phillipsmichaelSep 18, 2025
    Why do the light bulbs keep blowing on my Fantic Motor TZ 125 2011?
    • R
      Ryan AlvaradoSep 18, 2025
      If the light bulbs on your Fantic Motor Motorcycle are blowing, it could be due to a faulty voltage regulator. Remove the seat and the fuel tank, and check all connections, check the voltage regulator and the fuses in the fuse box.
  • K
    Kevin JohnsonSep 18, 2025
    Why does the lighting system not operate on my Fantic Motor TZ 125 2011 Motorcycle?
    • J
      johnleeSep 18, 2025
      If the lighting system on your Fantic Motor Motorcycle does not operate, it could be due to a blown lighting relay fuse. Remove the seat, the fuse box cover, and replace the fuse.
  • D
    David HillSep 7, 2025
    Why is the shock absorber on my Fantic Motor TZ 125 2011 set too hard?
    • L
      Laura RiddleSep 8, 2025
      If the shock absorber on your Fantic Motor Motorcycle is set too hard, it could be due to excessive front fork oil. Pour excess oil until reaching the correct oil level. Another cause might be front fork oil viscosity too high, drain fork oil and fill with correct fork oil viscosity. Also, tire air pressure set too high can cause this, so check tire air pressure. Finally, incorrect rear shock absorber adjustment can be the problem, so adjust rear shock absorber.
  • S
    Susan JohnsonSep 4, 2025
    What to do if Fantic Motor TZ 125 2011 Motorcycle brakes do not operate correctly?
    • S
      Shawn JacksonSep 5, 2025
      If the brakes on your Fantic Motor Motorcycle do not operate correctly, it could be due to worn discs, which would need replacing. Another potential cause is leaking brake fluid, so verify the brake circuits and replace any damaged or broken parts. Also, deteriorated brake fluid can cause issues, so drain the old brake fluid and fill with the new fluid recommended by the manufacturer. A broken pump piston would also prevent correct operation, replace the pump piston. Finally, incorrect brake adjustment can be the problem, so adjust the brakes.

Summary

FOREWORD

GENERAL CONTENTS AND CONSULTATION

Overview of manual contents for vehicle use and maintenance guidance.

MANUFACTURERS DATA AND EDITION

Contact details and publication information for FANTIC MOTOR.

HOW TO USE THIS MANUAL

SYMBOL EXPLANATIONS

Explanation of warning, caution, and note symbols used in the manual.

VEHICLE SPECIFICATIONS

ENGINE SPECIFICATIONS

Technical details of engine variants: 125, 200, 250, and 300 cc models.

TRANSMISSION SPECIFICATIONS

Details on transmission type, clutch, secondary drive, and gear ratios.

CHASSIS SPECIFICATIONS

Information on frame type, tire sizes, suspension, and fork details.

BRAKES AND DIMENSIONS

Specifications for brake disc diameter and overall motorcycle dimensions.

LOCATION OF COMPONENTS

SIDE STAND OPERATION

FUEL SYSTEM

RECOMMENDED FUEL

SERIAL NUMBER AND HOMOLOGATION

STARTING THE ENGINE

SHIFTING GEARS

STOPPING THE ENGINE

STOPPING THE MOTORCYCLE

BREAK-IN PERIOD RIDING

MAINTENANCE SCHEDULE

ELECTRONIC IGNITION SYSTEM

COOLING SYSTEM INSPECTION

COOLANT INFORMATION

COOLANT LEVEL MANAGEMENT

COOLANT LEVEL AND REPLACEMENT

SPARK PLUG MAINTENANCE

TRANSMISSION OIL MANAGEMENT

TRANSMISSION OIL LEVEL AND CHANGE

AIR CLEANER MAINTENANCE

THROTTLE CABLE ADJUSTMENT

CARBURETOR IDLE SPEED ADJUSTMENT

CLUTCH OPERATION AND ADJUSTMENT

EXHAUST SYSTEM MAINTENANCE

DRIVE CHAIN GUIDE AND INSPECTION

DRIVE CHAIN SLACK ADJUSTMENT

CHAIN AND SPROCKET WEAR

CHAIN GUIDE SLIDER AND SPROCKET INSPECTION

HANDLEBAR POSITION ADJUSTMENT

FRONT BRAKE LEVER ADJUSTMENT

REAR BRAKE PEDAL POSITION

BRAKE FLUID MANAGEMENT

STEERING SYSTEM ADJUSTMENT

STEERING ADJUSTMENT AND BLOCKAGE

STEERING PLATE FITTING AND ADJUSTMENT

FRONT FORK ADJUSTMENT OVERVIEW

REBOUND DAMPENING ADJUSTMENT

How to adjust the front fork's rebound damping to rider preference.

FRONT FORK DAMPING AND OIL LEVEL

FRONT FORK SPRING AND BRIDGE ADJUSTMENT

REAR SUSPENSION ADJUSTMENT

REAR SUSPENSION DAMPING AND SPRING

WHEELS AND TIRES MAINTENANCE

MOTORCYCLE CLEANING PREPARATION

MOTORCYCLE CLEANING PRECAUTIONS

BOLTS AND NUTS TIGHTENING

TORQUE VALUES TABLE

LUBRICATION POINTS

DRIVE CHAIN LUBRICATION

CARBURETOR TUNE-UP

CARBURETOR MIXTURE AND JET ADJUSTMENT

CARBURETOR SETTING TEST RUNS

SPARK PLUG CONDITION AND CORRECTION FACTORS

ALTITUDE AND TEMPERATURE CORRECTION CHART

SUSPENSION TUNE-UP GUIDE

SUSPENSION TROUBLESHOOTING

SYMPTOMS OF THE FRONT FORK

Identifies common stiffness or softness issues in the front fork and their causes.

SYMPTOMS OF THE REAR SHOCK ABSORBER

Identifies common stiffness or softness issues in the rear shock absorber.

DETERMINING THE PROPER SETTINGS

Guidance on evaluating and setting suspension for rider weight and conditions.

SUSPENSION SETTING CONSIDERATIONS

SUSPENSION ADJUSTMENT ISSUES

GEARSHIFT SELECTION AND TERRAIN CARE

FINAL RECOMMENDATIONS AND ADVICE

PREVENTIVE ADVICE

Essential pre-ride checks, periodic upkeep, and function checks.

SAFE RIDING OF YOUR MOTORCYCLE

Emphasizes driver intelligence, common sense, and safety equipment for riding.

LEGAL ADVICE

Notes on technical development, measurements, and liability exclusions.

HOMOLOGATION REQUIREMENTS

COMPETITION PREPARATION CHECKLIST

MOTORCYCLE STORAGE PROCEDURES

MULTIFUNCTION DISPLAY OPERATION

TECHNICAL CHARACTERISTICS OF DISPLAY

MULTIFUNCTION DISPLAY FUNCTIONS

DISPLAY SETTING PARAMETERS

DISPLAY UNIT AND TIME FORMAT SETTINGS

DANGER TEMPERATURE SETTING

WARNING TEMPERATURE SETTING AND DISPLAY RESET

INTERNAL BATTERY AND SCREEN FUNCTION

MULTIFUNCTION DISPLAY SCREEN OPTIONS

SLEEP MODE AND WHEEL CIRCUMFERENCE MEASUREMENT

TROUBLESHOOTING ENGINE ISSUES

TROUBLESHOOTING ENGINE AND GEARBOX ISSUES

TROUBLESHOOTING CLUTCH AND SUSPENSION ISSUES

TROUBLESHOOTING HANDLING AND ELECTRICAL ISSUES

WIRING DIAGRAM 125 cc

WIRING DIAGRAM 200-300 cc

WARRANTY TERMS AND CONDITIONS

WARRANTY PERIOD AND OBLIGATIONS

Defines warranty duration and purchaser's responsibilities for maintaining warranty validity.

WARRANTY EXCLUSIONS AND VARIOUS CLAIMS

Lists items not covered by warranty and procedures for handling warranty claims.

FAST GUIDE OF REFERENCE

LUBRICANTS TABLE

Fantic Motor TZ 125 2011 Specifications

General IconGeneral
BrandFantic Motor
ModelTZ 125 2011
CategoryMotorcycle
LanguageEnglish

Related product manuals