FANUC Power Mate Series User Manual

Power Mate Series Driver
GP-Pro EX Device/PLC Connection Manual
2
Introduction
This manual describes how to connect the Display and the External Device (target PLC).
In this manual, the connection procedure will be described by following the below sections:
1
System Configuration
This section shows the types of External
Devices which can be connected and SIO
type.
)"1 System Configuration" (page 3)
2
Selection of External Device
Select a model (series) of the External
Device to be connected and connection
method.
)"2 Selection of External Device" (page 7)
3
Example of Communication Settings
This section shows setting examples for
communicating between the Display and
the External Device.
)"3 Example of Communication Setting"
(page 8)
4
Setup Items
This section describes communication
setup items on the Display.
Set communication settings of the Display
with GP-Pro Ex or in off-line mode.
)"4 Setup Items" (page 11)
5
Cable Diagram
This section shows cables and adapters
for connecting the Display and the
External Device.
)"5 Cable Diagram" (page 14)
Operation

FANUC Power Mate Series Specifications

General

Control Type	CNC
Program Memory	Varies by model
Interpolation	Linear, Circular
Programming Method	G-code
Operating Temperature	0 to 45°C
Display	LCD
Interface	RS-232C, Ethernet
Memory Capacity	Varies by model
Humidity	20 to 80% (non-condensing)