ENGLISH
GB-35
2. Adjusting the minimum level of the ame
A
B
C
D
(A) Control
handle
(B) Valve
(C) Sealing
ring
(D)
Adjustment
screw
1. Turn the valves to the
minimum level.
2. Remove the valve knob and
place a small screwdriver at the
centre of the valve handle.
3. e correct adjustment is
reached when the ame has a
length of approximately 3 to 4
mm.
– For the butane/propane gas,
the adjustment screw must
be securely tightened.
– Put the control knob back
in its place.
– Make sure the ame does
not turn o quickly when
you turn the knob from
the maximum level to the
minimum level. If this is
the case, remove the control
knob and adjust the gas
ow, then test again once
the adjustment is made.
4. Repeat this procedure for each
of the gas valves.
To Next Page
Loading...
