ENGLISHENGLISH
GB-19GB-18
• e refrigerator inclination angle should be
less than 45°.
• Do not lay the unit fat as this may damage the
coolant system.
• You should rest the Appliance on something
solid e.g. a chair just below the top panel.
• We recommend that 2 people handle the unit
during assembly.
Deposit doors
1. Remove the right top hinge cover.
2. Remove the screws fixed the top hinge with
cross-slot screwdriver.
Screw
(two)
3. A. Remove the nut with sleeve. Take off the
washer then remove the axes to the other side
and fi ed.
B. Take off upper door then emove the door
limit block and place it to opposite side.
limit
block
4. Disassemble the screws fi ed the bottom
hinge with cross slot screwdriver.
Note: e efrigerator-freezer incline angle
less than 45 °.
e screws
Fixed the
Bottom-hinge
• To take the door off it is necessary to tilt the
unit backwards. You should rest the unit on
something solid so that it will not slip during
the door reversing process.
• All parts removed must be saved to do the
reinstallation of the door.
To Next Page
Loading...
