GB-21GB-20
illustrated below.
Full
3/4 full
1/2 full
1/4 full - Should rell to
eliminate spotting
Empty
C (Rinse-Aid indicator)
1. To open the dispenser, turn the cap to the
“open” (left) arrow and lift it out.
2. Pour the rinse aid into the dispenser, being
careful not to overll.
3. Replace the cap by inserting it aligned with
“open” arrow and turning it to the closed
(right) arrow.
NOTE: Clean up any rinse aid spilled
while during lling with an absorbent cloth to
avoid excessive foaming during the next wash.
Don’t forget to replace the cap before you close
dishwasher door.
Adjusting Rinse Aid Dispenser
Adjust lever (Rinse)
e rinse aid dispenser has six or four settings.
Always start with the dispenser set on “4”. If
spots and poor drying are a problem, increase
the amount of rinse aid dispensed by removing
the dispenser lid and rotating the dial to “5”.
If the dishes still are not drying properly or
are show spots, adjust the dial to the next
higher lever until your dishes are spot-free. e
recommended setting is “4”. (Factory value is
“4”.)
NOTE: Increase the dose if there are
drops of water or lime spots on the dishes after
washing. Reduce it if there are sticky whitish
stains on your dishes or a bluish lm on
glassware or knife blades.
To Next Page
Loading...
Need help?
General
