14
CLEANING AND MAINTENANCE
Proper maintenance will ensure many years of service from your appliance. Clean
the appliance after every use. The appliance contains no user serviceable parts and
requires little maintenance. Leave any servicing or repairs to qualied personnel.
WARNING:
- Always disconnect the plug (2) from the wall outlet before cleaning. Allow all
parts of the appliance to cool down completely.
NOTE:
- Do not immerse the power cord with plug (2) and blending base (5) into
water or any other liquid (ill.
s
). Do not use abrasive cleaners, steel wool or
scouring pads (ill.
t
). Dry all parts thoroughly after cleaning, before using or
storing the appliance. Ensure that no water enters the blending base (5).
- The blades are very sharp. Clean carefully. Danger of injuries!
- Clean the coupling (6) using a small brush.
WARNING:
- Any food residue left in the coupling (6) could damage the appliance causing
malfunction or possible injury.
- Do not immerse the attachments into water for extended periods of time.
Water could create issues with the bearings or gears and create a possible
malfunction.
• Only the chopping blade (8), chopping bowl (9), potato masher attachment (12)
and blending jar (14) can be immersed in water.
• After cleaning, place the attachments in an upright position to ensure that water
can be drained out.
• Clean the blending base (5) with a slightly damp, soft cloth.
NOTE:
- Always clean all parts that have come into contact with food in soapy water
immediately after use and before storage.
- Dry all parts and surfaces thoroughly before use. Make sure that all parts and
surfaces are completely dry before connecting the appliance to a wall outlet.
Cleaning between operation
In case the appliance needs to be cleaned before being used again to process
dierent food, follow below procedure:
• Immerse the bottom end of the attachment into a suitable tall container
containing lukewarm water.
• Press and hold the low speed button Lo (4) to switch on the appliance.
• After a few seconds, release the low speed button Lo (4) to switch off the
appliance.
Immersion Blender_201627_IM_US_V4_170620.indd 14 6/20/17 10:14 AM
To Next Page
Loading...
Need help?
General
