6
Care and Maintenance
1. After each use (and especially after the harvest season), always remove
the Display Module (if it is not inside a dry cab) and store in a clean and dry
place.
2. Always use plug cover on sensor cable connector to keep out dirt and mois-
ture!
3. The stainless contacts of the moisture sensor should be kept clean for best
results. Clean with fine steel wool and/or mineral spirits or alcohol. Dirty
sensor contacts can cause lower readings.
4. Check all nuts and bolts on sensor plate assembly and tighten, if nec
-
essary. Make sure that the leading edge is secured flat and tight to the
chamber wall.
To Next Page
Loading...