Farsun FG2600 - Page 5

5
The steps of programming are:
1. 6FDQWKH)XQFWLRQ6HWWLQJ%DUFRGH7KH6FDQQHUZLOOLVVXHDEHHS´
sound, and the Red LED is on until the program is finished.
2. Scan the parameters bar code. The parameters may be one or more than
one digits.
3. 6FDQWKHVHWWLQJEDUFRGH³)LQLVK6HWWLQJ´,ILWLVSURJUDPPHG
VXFFHVVIXOWKHVFDQQHUZLOOLVVXHD³EHHSEHHS´VRXQGEXWLVVXHD
³EHHSEHHSEHHS´VRXQGZKHQIDLOV
e.g.
˖
Set min. code length of Code 128 to 5 chars
˖
ƻ
1
˖Open the manual and turn chapter "code128 ". Scan the setting bar code
³Scan Min. Code Length´
Scan Min. Code Length˄2 Digits˗00~99ˈ1*˅
ƻ
2
˖Turn to the last page of this Manual Appendix 10 Parameter bar code,
VFDQWKHSDUDPHWHUEDUFRGH³´DQG  ³´˖
0
5