D1 IDENTIFICATION OF THE CRANE MODEL
The exact crane model, serial number and description of implements will
enable FASSI Service Department to give a rapid and efficient response.
D1.1 Crane mark
The CE indicates that the crane complies with the Machines
Directive (D.M.) 98/37; it can be considered effective only
with a written declaration of conformity enclosed. The crane
affixed with the CE mark is supplied with a lifting moment
limiting device to preserve the crane structure from over-
loads.
Identification data are marked on the plate DE1661 used for
the CE mark (fig. 2) and fixed on the base
1 - Crane model
2 - Serial Number
3 - Year of manufacturing
The crane must not be put into service within the European Community unless
the machine on which it is mounted also conforms with the prescribed Directive.
Ever change of use, modification or addition of accessories, not specified
by this manual must be affixed with a new CE mark in accordance with the
Machinery Directive.
A further metallic plate (fig. 3) fixed to the crane by the installer,
quotes the identifying data of the equipment and the final CE
mark.
1 - Name of the installer who applied the final
CE mark
2 - Crane mark, model and serial number
3 - Vehicle mark, model and chassis number
4 - Year of mounting
D1.2 Crane mark
Identification data of the crane are marked on the plate
DE2141 and fixed on the base. (fig. 4)
1 - Crane model
2 - Serial Number
3 - Year of manufacturing
(!) UNDER NO CIRCUMSTANCES SHOULD THE DATA
MARKED ON THE PLATES BE ALTERED.
D1
IDENTIFICATION OF
THE CRANE MODEL
F 170A
11
fig. 2
fig. 4
2
1
3
2
1
3
fig. 3
CRANE - MARK AND MODEL
SERIAL NUMBER
TRUCK - MARK AND MODEL
TRUCK FRAME SERIAL NUMBER
YEAR OF MOUNTING
2
3
1
4
To Next Page
Loading...