M0 MAINTENANCE INSTRUCTIONS
To assure a long life to the crane, it is necessary to meticulously follow the
maintenance instructions.
General lubrication and small repairs can be carried out by the user; repairs of a
more complicated nature must be carried out by authorized service personnel.
Spare parts must be original.
Good maintenance and proper use are imperative to maintain efficient use and
guarantee the safety of the crane.
At least once a y
ear you must take the crane to a Fassi Service Center for a
check.
(!) Before disconnecting any hydraulic hoses, ensure that there is no pressure in
the hydraulic circuit.
After removing hoses always mark them and their respective ports on the
crane. Faulty replacement can cause damage to the rams and to the hydraulic
circuit.
Respect the information supplied for maintenance and technical assistance.
Any maintenance operation must be carried out with the crane power source
turned off.
(in case of fixed mounting with hydraulic power pack, the electric
motor has to be turned off).
Do not place limbs, fingers or any other parts of anatomy into areas of the
crane, which present possibilities of shearing, without having blocked such
parts of the crane.
Do not weld, drill or grind any part of the crane without the Manufacturer’s
authorisation.
Do not weld the
fixing rods of the
crane (see plate
DE1574 fig. 29)
When repairs to,
or checks of, the
hydraulic circuit
and of the rams
are carried out, it is very important not to use, or be in the proximity of, mate-
rials which can damage the circuit or contaminate the hydraulic oil eg. metal
shavings, sand or dust.
Do not use the high pressure washing on the controls (deviators, distributors,
double controls, hand cable controls...), on the electronic components (boxes,
control panels...), on the tanks.
Never use detergents, petrolsol or inflammable liquids, always use non flam-
mable or non toxic liquids.
To avoid down time, it is recommended to periodically carry out the following
checks.
M0
MAINTENANCE
INSTRUCTIONS
F 170A
38
TIRANTI: NON SALDARE!
FIXING ROD: DO NOT WELD!
TIRANTS: NE PAS SOUDER!
ZUGSCHRAUBEN: NICHT SCHWEISSEN
DE1574
fig. 29
To Next Page
Loading...