23
TABLE OF HYDRAULIC
OIL AND LUBRICANTS
CHARACTERISTICS
GRU FASSI
23 TABLE OF HYDRAULIC OIL AND LUBRICANTS
CHARACTERISTICS
HYDRAULIC OIL WITH HIGH VISCOSITY: ISO-L-HV
Minimal external maximal oil Gradation
temperature: temperature:
-35°C +45°C ISO VG 32
-20°C +75°C ISO VG 46
HYDRAULIC OIL WEAR RESISTANT: ISO-L-HM
Minimal external maximal oil Gradation
temperature: temperature:
-10°C +60°C ISO VG 32
+ 0°C +75°C ISO VG 46
+ 5°C +85°C ISO VG 68
+10°C +90°C ISO VG 100
GREASE (for centralized system)
Use only GREASE NILEX EP1 of the firm NILS.
NOTE: Do not ABSOLUTELY mix different types of grease.
GREASE
(for slew ring, extension booms, outrigger supports...)
-30°C up to +130°C EP1 Gradation (cold climate)
EP2 Gradation (warm climate)
All grease used must be free from acid and resin, not hygroscopic and long-
life such as
BP GREASE LTX-EP1\EP2 or ELF EPEXA 1\2
ESSO BEACON EP1\EP2 or TEXACO EP1\EP2
MOBIL EP1\EP2 or SIMILAR.
HYDRAULIC OIL FOR MOTOREDUCER
Classification ISO-L-CC
Gradation EP ISO-VG 150
LUBRICATING OIL (for winch cable)
The most suitable here is a general-purpose lubricating oil with about SAE
30° viscosity. A lubricating oil containing non-stick additives is recommended
if the cables are expected to move quickly through the pulleys.
BRILUBE 50 (BRITISH ROPES - BRINDON)
( ! ) WARNING ( ! )
Don’t use greases with solid particles as “Bisulphide of Molybdenum”
(not compatible with eventual teflon bushes).
To Next Page
Loading...