What to do if new software is not working on Fast & Fluid Management TM300 Dispenser?
If your Fast & Fluid Management Dispenser's software isn't working, the program may not have booted correctly, so reboot your computer and the software. Alternatively, the software might be incorrectly installed, in which case you should reinstall it.
Why is there no power from the power unit of my Fast & Fluid Management TM300?
If your Fast & Fluid Management Dispenser shows no power, first check the power cables to ensure they are connected to the power grid. If the cables are fine, the fuse may have blown. Remove the plug from the socket and replace the fuse.
Why are colors difficult to reproduce with my Fast & Fluid Management Dispenser?
If the colours are difficult to reproduce with your Fast & Fluid Management Dispenser, the mechanisms might be dirty, so clean and oil them. It could also be due to quality fluctuations in the paste supplied, in which case you should contact your paste supplier. Thickened pastes can also cause this issue, so replace any thickened paste(s). Finally, the turntable might be in the wrong position; reset it by pressing and unlocking the emergency stop button. Leaks around the pistons can also cause this problem. In this case, the pistons should be replaced “Service”.
What to do if the keyboard is not working on my Fast & Fluid Management TM300?
If your Fast & Fluid Management Dispenser's keyboard isn't working, start by checking the cables to ensure they are properly connected. The issue may also be related to an incorrect Windows Regional setting, in which case you should check the Windows software manual. Defective cables or keyboard may also be a reason. In this case, the cables or keyboard should be replaced “Service”.
Why is the monitor picture poor or not showing on my Fast & Fluid Management Dispenser?
If the monitor picture is poor or there's no picture on your Fast & Fluid Management Dispenser, first ensure the monitor is switched on. Next, check the cables to make sure they are not loose. If the picture is too dark, adjust the picture settings correctly. If none of these steps work, the monitor may be malfunctioning “Service”.
What to do if the stirrer is not rotating on my Fast & Fluid Management TM300 Dispenser?
If the stirrer is not rotating on your Fast & Fluid Management Dispenser, the timer setting may be incorrect. Set the timer correctly using the software. Also, check the cable to ensure it is not loose. Defective cable or motor may also be a reason. In this case, the cable or motor should be replaced “Service”.
Why is the turntable not turning on my Fast & Fluid Management TM300 Dispenser?
If the turntable is not turning on your Fast & Fluid Management Dispenser, the piston rod may be positioned too high. Set the piston in a lower position. Also, check the cables to make sure they are not loose. Defective cable or motor may also be a reason. In this case, the cable or motor should be replaced “Service”.
What to do if air is being fed together with the paste in Fast & Fluid Management Dispenser?
If air is being fed together with the paste in your Fast & Fluid Management Dispenser, there may be an air bubble in the pump. Prime the pump to resolve this. Another possible cause is an empty canister; refill it. If the problem persists, the piston may be defective, in which case you should replace the pump “Service”.
Why is the valve leaking through the outlet opening of my Fast & Fluid Management Dispenser?
If the valve leaks through the outlet opening on your Fast & Fluid Management Dispenser, it could be due to an air bubble in the pump; prime the pump. Alternatively, the valve may be defective, and you should replace the pump “Service”.
What to do if canister connection leaks around the suction point on Fast & Fluid Management Dispenser?
If the canister connection leaks around the suction point on your Fast & Fluid Management Dispenser, the O-ring(s) may be worn. Replace the O-ring(s) “Service”.
General| Brand | Fast & Fluid Management |
|---|---|
| Model | TM300 |
| Category | Dispenser |
| Language | English |
To Next Page
