10
SHIRTS & SKIRTS
Place the sleeve on the ironing board
and make sure the top of the sleeve is
placed suitably to the shape of the
board. Press.
Cuffs can be pressed flat easily. Use
the long cushion provided for difficult
cuffs.
Press the part that cannot be pressed
on the ironing board, like the shoulders
of the blouses, by supporting them with
the small cushion provided and by
rubbing them against the pressing plate.
Press the skirts by slipping the skirt
over the ironing board.
AUTOMATIC SAFETY SHUT OFF:
Your press is equipped with safety timer, which turns off the
heating elements and alerts you with a beep signal under the
following conditions.
• When the power is initially turned on and the press is closed.
• When the press is left closed for more than 30 seconds.
• When the press is left in the open position for approximately
20 minutes during the first cycle, or 8 minutes during all following
cycles.
To turn the beep signal off and the power back on, move the
handle up and down or open the press, turn the on/off switch
off and then on again.
HOW TO USE THE PRESSING CUSHIONS:
Pressing cushions are supplied with your press to be used as
ironing aids on areas that can not be pressed flat and when
pressing areas such as darts, shoulder seams, etc. as well as to
give the desired shape to tailored garment and prevent pressure
marks from pockets etc
• Place the part of the garment on the ironing board.
• Place the pressing cushion under the specific area to be
pressed i.e. under the dart, etc.
• Lower the pressing plate. The raised cushion will allow the
pressing plate to touch only the specific area to be pressed
• Please note: The press cannot be completely closed when
using a pressing cushion. Forcing the handle down can damage
the press. Therefore keep the handle at a position to exert just
enough pressure for ironing.
7
To Next Page
Loading...