1 2
• Never point or press the tool in the direction of yourself or
another person.
Contact FastenMaster at 800-518-3569 with any questions
related to the safe operation of the PAMFast tool prior to use.
a Precautions:
• Only use genuine PAMFast collated fasteners approved for
the PAMFast AutoFeed tool. The use of any other fastener is
not advised and will void the PAMFast limited warranty.
• Only use genuine PAMFast AutoFeed driver bits approved for the
PAMFast AutoFeed tool. The use of any other driver bit will result
in poor performance and will void the PAMFast limited warranty.
• Only use screw guns that are supplied with the PAMFast
AutoFeed tool or recommended by FastenMaster.
The use of any other screw gun may result in poor
performance and will void the PAMFast limited warranty.
• Always disconnect power prior to loading collated screw
strips into the belt guide, replacing driver bits, or performing
any adjustments or maintenance.
• Do not plug into AC outlet or install battery prior to reading.
• Do not operate any PAMFast tool without reading and
understanding all safety warnings and operating instructions.
Failure to abide by the warnings and operating instructions in
this manual may result in personal injury, injury to others, or
property damage.
• Any screw gun that is supplied with any PAMFast tool is not
manufactured or warrantied by FastenMaster. Screw gun
manufacturer warranties, operating instructions, and safety
warnings are provided by the manufacturer and must be read
and understood prior to operating. Failure to abide by the screw
gun manufacturer’s safety warnings and operating instructions
may result in personal injury, injury to others, or property
damage.
• Always disconnect power by unplugging from AC outlet
or removing battery prior to performing any adjustments,
driver bit changes, maintenance, or repairs.
• Always be aware of job site risks. Active job sites present a
number of safety risks, including but not limited to those that
may result in trips, falls, cuts, slips, etc. Some job sites present
greater hazards than others. The use of appropriate personal
protective equipment (PPE) including protective eye-wear, non-
slip protective footwear, and protective head-wear is required
when using any PAMFast AutoFeed tool. Additional PPE may be
required depending on the conditions of the job site. Refer to
the Occupational Safety and Health Administration (OSHA) or
prevailing governing body for a full list of PPE requirements and
safety guidelines.
• Always be aware of what lies below the surface. Electrical, gas,
and plumbing utilities may present a danger. Never install any
fastener prior to assessing potential risks.
• Ensure that all work surfaces are stable, secure, and free
from debris that may lead to trips, falls, or other injury.
Safety
To Next Page
Loading...