Caution
Make sure the connector is firmly attached.
Keep the vehicle ignition key ON or the engine running.
Accessories connector:
OBD-16 pin connector supports J1708/J1587 or J1939
protocol.
DIESEL-9 pin connector supports J1708/J1587 protocol
and J1939 protocol.
DIESEL-6 pin connector supports only J1708/J1587
protocol.
CAT-9 pin connector supports J1708/J1587 or J1939
protocol.
TROUBLESHOOTING GUIDE
If the F506 fails to connect to the vehicle:
1. Make sure the vehicle ignition key is in the ON
position;
2. Make sure pins in connectors are not bent and
contacted;
3. Make sure the cable connectors are plugged in firmly;
4. Make sure the diagnostics connector is clean.
How to self-test the F560:
Connect the power interface of the main test line, and
then connect it to the 12V DC power supply. The F506
starts and then enters the system settings/SELF-TEST to
test if the F560 is normal or abnormal (refer to Fig.12).
To Next Page
Loading...