How to display decimal point on FE PXR5?
If a decimal point has not been displayed on your FE Microcontroller, it might be because “0” is set in the parameter . To display the decimal point, set the parameter to “1” or “2”.
Why does the display on my FE PXR5 Microcontrollers show incorrect values?
If the display on your FE Microcontroller is showing unexpected values, it could be due to several reasons. First, the setting might not be correct for the input signals from sensors. Also, check if the polarity of the sensor matches the PXR; if not, correct it. Input terminals may be short-circuited in thermocouple B or R; in this case, set the parameter to 3 and check the temperature. The input signals of sensors might not match those of your controller, which may require adaptations or a replacement. Ensure the connecting cables for the sensor are tightened. Finally, a break or short-circuit in the sensor, or issues with the sensor or other input devices connected to the PXR, could be the cause; replace the sensor or input devices as needed. Also, verify that the set value of parameter ...
Lists all parameters with their settings, ranges, and cross-references to pages.
Explains fundamental operations like changing parameters, setting values, and mode switching.
Details specific parameter functions and provides step-by-step guides for their configuration.
Sets the lower limit for the Setting Value (SV) to constrain its range.
Addresses risks of unwanted continued heating and system design considerations.
General| Brand | FE |
|---|---|
| Model | PXR5 |
| Category | Microcontrollers |
| Language | English |
To Next Page