EasyManua.ls Logo

Fedders A6P09S2B - Maintenance & Service; Cleaning and Maintenance; Draining Excess Water; Service Instructions

Fedders A6P09S2B
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE &
SERVICE
/
Cleaning and Maintenance
The unit has an air filter that must be cleaned with water
every two weeks and put back in the unit after it is
completely dry.
The air discharge grille can be cleaned with a rag or
sponge, warm water and mild detergent.
Never use hot water, bleach, gasoline, acids, cleaning fluid
or a brush to clean the unit. This will damage the cabinet
and the air discharge area.
Do not wash the unit with a hose.
Before using at the start of a season
Clean the air filter.
Clean the cabinet and air discharge areas if necessary.
Draining excess water
Drain excess water from the tank by placing a pan under
the lower drain valve, remove the drain plug, and let the
water drain into the pan. When the water stops draining out,
replace the drain plug, put the tube back in the clip pointing
up, and remove the pan of water. Operate the air conditioner
in fan mode to dry the interior of the unit.
Removing the Filter
Service Instructions
Read carefully before calling for service
If the unit fails to start
Make sure the unit is plugged into an outlet.
Make sure the unit is not in the off position.
Make sure the circuit breaker has not been tripped.
If the unit does not cool sufficiently
Make sure the exhaust tube and nozzle fit correctly to
each other and to the window adapter.
Make sure the exhaust tube is not bent.
Adjust the thermostat to a lower temperature.
Make sure the exhaust tube and nozzle have nothing
inside them.
If the unit is too loud
Make sure the exhaust tube and nozzle fit correctly to
each other and to the window mount.
Make sure the exhaust tube and nozzle have nothing
inside.
Air Conditioner Remote Control
The functions work the same
as your air conditioner's touch
controls.
Batteries: Remove the cover
on the back of the remote
controller and insert the
batteries with the (+) and (-)
poles pointing in the proper
direction.
CAUTION:
Use only AAA or
IEC R03 1.5V batteries.
Do not attempt to recharge the supplied
batteries
All batteries should be replaced at the
same time.
Do not dispose of the batteries in a fire as
they may explode.
Do not mix old and new batteries.
Do not install the batteries with the
polarity (+/-) reversed.
Keep batteries and other things that could
be swallowed away from young children.
Contact a doctor immediately if an object is
swallowed.
6

Related product manuals