Fedders A6P09S2B - Operation; Electronic Controls Overview; Power Control; Mode Control

Power
OPERATION _']
ELECTRONIC CONTROLS J
Warning
Light
Power
Control
Mode
Control
Dehumidify Med
FEDDEI
Fan Speed
Control
Display Timer Timerfremp
Mode Control Controls
Indicators
play
AO
Mode
Power Control
The power control turns the unit on and off.
FanSpeed
Warning Light
This light indicates that the internal water tank needs T,;_
to be drained. The unit will not operate until the
water has been drained. See the next page of this __--
owners' manual for instructions on how to drain the TJmor
water.
Mode Control
The Mode Control has 3 settings: Cool,Dehumidify,
and Fan.
The settings are adjusted with the Mode Control
button. A green light will indicate which setting is
currently being used.
(_ Cooling Mode
Cool
During the cooling mode the air is cooled and
hot air is exhausted to the outside air through
the exhaust tube.
Fan Speed
The Fan Speed Control has 3 settings: High, Medium,
and Low.
Timer
Auto turn off:
With machine in fan mode, press timer button
to select number of hours you would like the unit
to run in airconditioning mode until it
automatically shuts off.
Auto turn on:
With machine powered off, press timer button
to select number of hours until you would like
the unit to automatically start running in
airconditioning mode.
__OvTimer/Temperature buttons
Used for adjusting the timer and thermostat.
The default display is room temperature.
Dehumidify
Adjust fan speed and temperature to suit your
desired comfort level.
Dehumidify Mode
Air is dehumidified as it passes through air
conditioner, without being in full cooling mode.
(Note: The warm air exhaust hose must vent inside
the room when using Dehumidify Mode, not
outside as it does when cooling. If the unit is
vented outside some cooling will occur.)
Fan Mode
Air is circulated throughout the room with no
cooling. (Note: unit does not need to be vented in
Fan mode.)
When "+" or "-" button is pressed, the set
temperature is displayed and may be adjusted. After
15 seconds the display will revert back to room
temperature.
By depressing both buttons at once, the display will
toggle between Celsius and Fahrenheit.
5