3. Operation
5. Adjusting belt
Release the shoulder belt from the harness yoke on the back of backrest as shown in the picture ①.
Release the connection of shoulder pad yoke on the back of the backrest as shown in the picture ②.
Push in the shoulder belt and shoulder pad yoke through the belt inlet hole as shown in the picture ③.
Position the belt at the desired height as shown in the picture ④ and fix the shoulder straps and
shoulder pad straps to corresponding yokes.
Place the shoulder belts at the same height level as shown in the picture ⑤.
Checking the correct
completion
Following points should be checked in order to make sure of proper functioning
of child seat.
Both shoulder belts are firmly hanged to harness yoke.
Child shoulder pad straps are securely hanged to yoke.
Child belts are inserted through the same height of holes.
Child belts are not twisted or loosened.
Warning
Position of belt inlet hole and the length of child belts are adequate.
Child belts are correctly fastened to the baby’s shoulders.
Without proper adjustment in accordance with the above checkpoints, child may be bounced
out of the seat at the time of car crash.
Do not use the product over one hour consecutively.
To Next Page
Loading...