Spooler Manual
User Manual
13
Set Diameter:
1.75
Set PullSpeed:
1.18
Spooler ready!
> Diameter: 1.75
Set Travel:
80
80mm
The second parameter is the diameter you would like to obtain.
The sysytem will remember your last choice for the next extrusion.
Click to confirm.
This parameter is about the spool width. Measure it and set the distance.
Click to confirm.
If you are working in “Manual Mode” this parameter indicates the puller whells constant
speed (meter per minute). Adjust it according to your extrusion flow.
Felfil Spooler is ready to be used.
You can set it form a minimum of 0.5mm to a
maximum of 3mm.
This parameter is settable only in “Manual
Mode”
!
To Next Page
Loading...
