Spooler Manual 19
Usage
For a correct usage of Felfil Spooler please follow these suggestions:
- Place it on a flat and stable surface before operating (a table is quite good);
- Do not place anything near Felfil Spooler, it requires unrestricted airflow, for cooling,
proper operation and to protect the electronic components from overheating;
- Do not operate the machine for more than 4 hours. After that cycle, please could it down for
2 hours;
The first meters of filament will be inconsisten on diameter. Do not use this filament in your 3D
printer.
If you have any problems using Felfil Spooler, contact support@felfil.com.
Felfil Spooler needs some occasional maintenance:
- Clean it regulary
- Be sure that every part can spin properly
- Use always gloves while working on still hot components.
?
Usage
?
Maintenance
To Next Page
Loading...
