How to fix a Fellowes Paper Shredder that operates only in REVERSE?
If your Fellowes Paper Shredder operates only in REVERSE, a small piece of paper may be blocking the auto-start sensor. To fix this, move the power switch to the OFF (O) position and unplug the shredder. Turn the shredder over and use a toothpick from the underside of the unit to clear the paper blockage at the auto-start sensor location in the center.
Why does my Fellowes Paper Shredder run continuously in AUTO?
If your Fellowes Paper Shredder runs continuously when in AUTO, a small piece of paper may be causing the auto-start feature to run continuously. To resolve this, move the power switch to the OFF (O) position and unplug the shredder. Use a toothpick from the top of the unit to clear any paper blockage at the auto-start sensor located in the center.
What to do if my Fellowes P600C-2 suddenly stops while shredding?
If your Fellowes Paper Shredder suddenly stops while shredding, it could be due to two reasons. First, the shredder may have exceeded the maximum run time and requires a cool-down period. Second, the shredder might be jammed. In this case you should follow the instructions for clearing a jam.
Why does my Fellowes Paper Shredder shred less than capacity?
If your Fellowes Paper Shredder shreds less than its capacity, the cutting blades may need to be oiled regularly. See the MAINTENANCE section for instructions.
How to reduce squeaking noise in Fellowes P600C-2?
If your Fellowes Paper Shredder makes a loud squeaking or rubbing noise, the cutting blades need to be oiled regularly. Refer to the MAINTENANCE section for instructions.
Main guide for operating and caring for the Fellowes Personal Series paper shredder.
Details sheet capacity, shred type, entry width, recommended daily use, and maximum running time.
Essential safety advice, including warnings about fingers, children, pets, and hazardous materials.
Step-by-step guide for correctly assembling the shredder head onto the waste basket.
Instructions for using the shredder, auto-start sensor, and understanding cool-down periods.
Steps to follow if the shredder jams, including using reverse and manual removal.
Guidance on regularly oiling the cutting blades for optimal performance and longevity.
Addresses common problems like shredder not operating, noise, jams, and reduced capacity.
Outlines the warranty period and conditions for the shredder and its parts.
Provides customer service phone numbers and the official company website for assistance.
General| Sheet Capacity | 6 sheets |
|---|---|
| Security Level | P-4 |
| Bin Capacity | 6 Gallons |
| Run Time | 5 minutes |
| Cool Down Time | 30 minutes |
| Can Shreds | Paper, Credit Cards, Staples, Paper Clips |
| Auto Start/Stop | Yes |
| Warranty | 1 year |
| Cut Type | Cross-Cut |
To Next Page
