Felt AR - Rear Grommet & Mousetail

a. If no Cable Stop is
present on drive-side
dropout, locate the
Dropout Cable Stop so
the rear derailleur cable
can be installed.
b. Insert the shaft of the
Dropout Cable Stop so
it looks like the figure
below.
c. Thread a shifter cable into the Mousetail
Ferrule. Next, thread the cable though the
dropout grommet and advance the cable until
it exits the hole in the bottom bracket. Slide the
Mousetail toward the end of the shifter cable,
until the ferrule meets the dropout grommet.
When finished, remove the shifter cable.
Step 3
Rear Grommet &
Mousetail
-28-