Need help?Do you have a question about the Fender 1000 Roc-Pro and is the answer not in the manual?
General| Output Power | 100 Watts |
|---|---|
| Channels | 2 |
| Speaker | 1x12" Fender Special Design Speaker |
| Tube | 1 x 12AX7 (Preamp) |
| Type | Hybrid |
| EQ | 3-band EQ |
| Dimensions | 10.5" |
| Outputs | 1 x 1/4" (Headphone/Line out), 1 x 1/4" (External speaker) |
Crucial instructions on electrical safety, unit handling, and maintenance.
Adjusts guitar input, overall loudness, and primary EQ settings (bass, mid, treble).
Manages pre-amp gain levels and switches between two distinct pre-amp circuits.
Fine-tunes tone post-distortion and selects between Normal and Drive channels.
Controls reverb, effects mix, footswitch connection, and amplifier power status.
Jacks for power input, speaker outputs, line out, and effects loop.
Switch to control signal level sent to and received from effects units.
Instructions for replacing the 12AX7A vacuum tube in the amplifier.
Key technical data including power, impedance, output, and physical dimensions.
To Next Page
