5
O. IEC LINE CORD CONNECTOR - The power
line cord must be connected to a grounded AC
receptacle in accordance with the voltage and
frequency ratings as shown on the Rear Panel
of the unit INPUT POWER {P}.
Q. EXTERNAL SPEAKER - Connect an external
speaker (8Ω) at this jack. The internal speaker
is automatically disconnected. NOTE: Switch
unit OFF before making speaker connections.
R. TUNER OUT - Connect your bass
guitar-tuner here. This output jack is
NOT disabled by Front Panel M U T E
switch, allowing quiet tuning with the
bass guitar plugged into the unit.
S. LINE OUT - Connect recording or
sound reinforcement equipment at this
output jack.
T. EFFECTS SEND - Connect cable to external
effects devices at this output jack.
U. EFFECTS RETURN - Connect cable f ro m
external effects devices at this input jack.
• NOTE: Link two Bassman 25’s together using
the EFFECTS jacks. Connect the
EFFECTS SEND {T} from the “master unit” to
the EFFECTS RETURN {U} of the “clone unit.”
T Y P E PR 422
PART NUMBERS 022-4501-000 (120V), 022-4531-000 (240V) A u s t ,
022-4541-000 (230V) UK, 022-4561-000 (230V) Eur,
022-4571-000 (100V)
POWER REQUIREMENTS 100V AC, 50/60Hz: 75W, 120V AC, 60Hz: 75W,
230V AC, 50Hz: 75W, 240V AC, 50Hz: 75W
POWER A M P L I F I E R O U T P U T: 25W RMS into 8 Ω @ <5%THD
S E N S I T I V I T Y: 2V RMS
PRE A M P L I F I E R INPUT IMPEDANCE: I N P U T 1: 34k Ω, I N P U T 2: 68k Ω
S E N S I T I V I T YFOR FULL P O W E R : I N P U T1: 250mV, I N P U T 2: 500mV
N O M I N A LL E V E L : I N P U T 1: 50mV, I N P U T 2: 100mV
TONE CONTROLS BASS: +/-15dB @ 80Hz
MID LEVEL: +/-15dB @ 1.5kHz
TREBLE: +/-15dB @ 8kHz
EFFECTS LOOP SEND IMPEDANCE: 1k Ω
RETURN IMPEDANCE: 44k Ω
N O M I N A LL E V E L : 0 d B u
S P E A K E R Fender Special Design 8 Ω, 10,” (Part#0038657000)
D I M E N S I O N S H E I G H T: 16.5 in. (41.9 cm)
W I D T H : 15 in. (38.1 cm)
D E P T H : 15 in. (38.1 cm)
W E I G H T 33 lb. (15 kg)
Product specifications are subject to change without notice.
To Next Page
Loading...
