Need help?Do you have a question about the Fender BXR 200 and is the answer not in the manual?
Power| power requirements 100V version | 100VAC, 50/60Hz, 540W |
|---|---|
| power requirements 120V version | 120VAC, 60Hz, 540W |
| power requirements 230V version | 230VAC, 50Hz, 540W |
| power requirements 240V version | 240VAC, 50Hz, 540W |
| power output | 200W R.M.S. |
Weight and Dimensions| height | 25-1/2 inches (64.8 cm) |
|---|---|
| width | 21-1/2 inches (54.6 cm) |
| depth | 13-1/2 inches (34.3 cm) |
| weight | 72 lbs. (32.7 kg) |
Power| power requirements 100V version | 100VAC, 50/60Hz, 540W |
|---|---|
| power requirements 120V version | 120VAC, 60Hz, 540W |
| power requirements 230V version | 230VAC, 50Hz, 540W |
| power requirements 240V version | 240VAC, 50Hz, 540W |
| power output | 200W R.M.S. |
Weight and Dimensions| height | 6-29/32 inches (17.5 cm) |
|---|---|
| width | 21-1/2 inches (54.5 cm) |
| depth | 13-1/2 inches (34.3 cm) |
| weight | 27 lbs. (12.3 kg) |
High impedance, high sensitivity plug-in connection for instruments.
Connection for instruments with active pickups. Handles higher RMS voltage.
Boosts and extends the low frequency response of the amplifier.
Removes midrange, making the amp sound punchy for specific playing styles.
Adds high frequency "sparkle" to the sound.
Adjusts the gain of the pre-amplifier, serving as loudness adjustment.
Adjusts the low part of the frequency spectrum for fundamental tones.
Adjusts the high end of the frequency spectrum for added sparkle.
Precise tonal adjustment via 9 bands, +/- 12 dB boost/cut.
Adjusts the sweep rate of the chorus generating circuitry.
LED illuminated when chorus is active, modulated by LFO.
Adjusts the intensity of the chorus effect, from subtle to dramatic.
Activates chorus circuitry for a fuller, more colorful sound.
Plug-in connection for remote footswitch to control chorus.
Fender's exclusive circuit to prevent power amp clipping.
LED indicates power amp has reached full power or limiting.
Illuminated LED indicates the unit is receiving power.
Turns the BXR 200 unit "ON" or "OFF".
Grounding type supply cord for safety. Connect to grounded receptacle.
Line level outputs for driving slave amps or studio recording.
Connections for speaker cabinets; minimum 4 ohms total impedance.
Preamp output for external effects or mixers (dry signal).
Input for effects or slave amps, bypasses preamp circuitry.
To Next Page
