A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORP.,
CORONA, CA 91720
Part Number: COMBO HEAD
100V 022-4475-000 022-4476-000
120V 022-4405-000 022-4406-000
230V 022-4465-000 022-4466-000
230V UK 022-4445-000 022-4446-000
240V AUSTRALIA 022-4435-000 022-4436-000
Type Specification: PR286
Power Requirements: 100V Version: 100VAC, 50/60Hz, 540W
120V Version: 120VAC, 60Hz, 540W
230V Version: 230VAC, 50Hz, 540W
240V Version: 240VAC, 50Hz, 540W
POWER AMPLIFIER SECTION:
Power output: 200W R.M.S.
Rated load impedance: 4 Ω
Distortion at 200 watts: Less than .1% @ 1 kHz, below compression
Less than 1% @ 1 kHz, maximum compression
Sensitivity: 1.03V R.M.S.
Input impedance: 22 kΩ
DELTACOMP (tm) range: 20 dB
PREAMP SECTION:
Input impedance: Input 1 - Greater than 420 kΩ (typically greater
than 1 MΩ in the passband)
Input 2 - 136 kΩ
Sensitivity for 200 W: Input 1 - 2.2 mV
GAIN at maximum, all Input 2 - 4.4 mV
tone controls at “0”
detent, no enhancement
activated.
Shelving tone controls: LOW +/- 12 dB at 60 Hz
HIGH +/- 12 dB at 10 kHz
Graphic equalizer: +/- 12 dB at 80, 140, 250, 450,
800, 1.4k, 2.5k, 4.5k, and 8 kHz.
PHYSICAL SPECIFICATIONS:
BXR 200 COMBO BXR 200 HEAD
Height: 25-1/2 inches (64.8 cm) Height: 6-29/32 inches (17.5 cm)
Width: 21-1/2 inches (54.6 cm) Width: 21-1/2 inches (54.5 cm)
Depth: 13-1/2 inches (34.3 cm) Depth: 13-1/2 inches (34.3 cm)
Weight: 72 lbs. (32.7 kg) Weight: 27 lbs. (12.3 kg)
Speaker: 15” 4 Ohm Fender Special Design (P/N 048941), Combo only.
WARNINGS: NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
THIS EQUIPMENT MUST BE EARTH GROUNDED.
BXR 200 SPECIFICATIONS
To Previous Page
Loading...
