ACOUSTASONIC 30 - REAR PANEL
1
1. IEC LINE CORD CONNECTOR - The line cord
must be connected to a grounded AC recepta-
cle in accordance with voltage and frequency as
shown in the INPUT POWER rating on the rear
panel of the amplifier.
WARNING ! - READ ALL INSTRUCTIONS BEFORE OPERATING UNIT!
TYPE: PR 423
PART NUMBER: 22-1303 (120V); 22-1333 (240V) Aust;
22-1343 (230V) UK; 22-1363 (230V) Eur;
22-1373 (100V)
POWER REQUIREMENTS: 100V AC, 50/60 Hz, 90W; 120V AC, 60 Hz, 90W;
230V AC, 50 Hz, 90W; 240V AC, 50 Hz, 90W
POWER AMPLIFIER OUTPUT: 30W RMS into 8Ω @ < .17% THD
PREAMP SECTION
INPUT IMPEDANCE: 10MΩ (Inst), 3.6kΩ (Mic)
SENSITIVITY FOR
FULL POWER: 7.5mV (Inst), 4.5mV (Mic),
TONE CONTROLS: Treble: +/-15dB @ 15kHz (Inst), +/-15dB @ 15kHz (Mic)
Mid: +/-12dB @ 1kHz (Inst)
Bass: +/-12dB @ 100Hz (Inst), +/-12dB @ 50Hz (Mic)
STRING DYNAMICS: 0 to -15dB @ 6.3kHz (Instrument Channel)
PHANTOM VOLTAGE: +15V DC (Mic)
SPEAKER COMPLEMENT: Single Fender Special Design 8” speaker (P/N 051016)
Single Piezo Horn (P/N 049260)
DIMENSIONS: Height: 15 3/8 in 39 cm
Width: 19 3/8 in 49 cm
Depth: 14 5/8 in 37 cm
Weight: 34 lb 15.4 kg
Fender
®
, Tone-Master
®
and Princeton
®
Chorus are registered trademarks of FMIC.
Product specifications are subject to change without notice.
ACOUSTASONIC 30 SPECIFICATIONS
• TO PREVENT DAMAGE, FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
• NO USER SERVICEABLE PA RTS INSIDE,
REFER SERVICING TO QUALIFIED PERSON-
NEL ONLY.
• DO NOT ALTER THE AC PLUG.
• THIS UNIT MUST BE EARTH GROUNDED.
• UNPLUG THE AC POWER LINE CORD
BEFORE CLEANING THE UNIT’S COVERING
WITH ONLY A DAMP CLOTH; WAIT UNTIL
THE UNIT IS COMPLETELY DRY BEFORE
RECONNECTING IT TO POWER.
5
To Next Page
Loading...
