Do you have a question about the Fender CHAMPION 110 and is the answer not in the manual?
Power Output | 25 watts |
---|---|
Effects | Reverb |
Channels | 2 (Clean and Drive) |
Inputs | 1 x 1/4" instrument input |
Outputs | 1 x 1/4" (Headphones/Line Out) |
Speaker | 10-inch Fender Special Design speaker |
High impedance, high sensitivity plug-in connection for instruments.
Adjusts the overall loudness of the Normal Channel.
Adjusts preamp amplification for more sustain and distortion in the Drive Channel.
Activates the Drive Channel, disabling the footswitch and Normal Channel Volume.
Adjusts the overall loudness of the Drive Channel.
LED illuminated when the Drive Channel is active.
Adjusts the amount of boost or cut in the high frequency range.
Adjusts overall tone quality, affecting midrange frequencies for tone shaping.
Adjusts the amount of boost or cut in the low frequency range.
Adjusts reverberated signal mixed with the original dry signal.
Connection for optional remote footswitch to switch between Normal and Drive channels.
Output to an external 8 Ohm speaker enclosure, disabling the internal speaker.
Output for headphones, disabling the speaker. Caution: high levels may harm hearing.
Indicates when the CHAMPION 110 is receiving AC power.
Turns the AC power ON and OFF. Amplifier is completely shut down when OFF.
Identifies specific versions of the 120V and 230V models.
Specifies the input impedance of the amplifier as greater than 1 meg Ohm.
Indicates the nominal input level the amplifier is designed to receive.
States the amplifier's power output as 25 Watts R.M.S.
Specifies the rated load impedance for the amplifier, which is 8 Ohms.
Details the power requirements for both 120V and 230V versions.
Describes the included speaker as one 8 Ohm Special Design 10" speaker.
Provides the height, width, and depth measurements of the amplifier.
States the total weight of the amplifier in pounds and kilograms.
Lists available accessories, such as the remote single footswitch.