Need help?Do you have a question about the Fender '68 CUSTOM PRO REVERB and is the answer not in the manual?
General| Type | Tube Amplifier |
|---|---|
| Output Power | 40 Watts |
| Tremolo | Yes |
| Effects | Reverb, Tremolo |
| Speaker | 12" Celestion |
| Inputs | 2 x 1/4" |
| Channels | 2 (Normal, Custom) |
| Reverb | Yes |
| Tubes | 3 x 12AX7, 12AT7, 2 x 6L6 |
| Controls | Volume, Treble, Bass, Reverb, Speed, Intensity |
| Outputs | External Speaker Jack |
| Footswitch | Yes (Channel Switching and Reverb) |
Connect instruments here. Input 1 offers higher sensitivity.
Provides a high-frequency boost that tapers off as Volume increases.
Controls the overall volume level of the amplifier.
Adjusts the high-frequency tonal character.
Adjusts the mid-frequency tonal character.
Adjusts the low-frequency tonal character.
Controls the reverb effect level; can be toggled with footswitch.
Controls the tremolo effect rate; can be toggled with footswitch.
Controls the tremolo effect depth.
Illuminates to indicate when the amplifier is powered on.
Explains the function of the Power and Standby switches for operation and tube life.
Details the IEC power inlet and fuse for power connection and safety.
Describes internal and external speaker connections and impedance requirements.
Specifies where to connect the included two-button footswitch.
To Next Page