Need help?Do you have a question about the Fender Rumble 100 (V3) and is the answer not in the manual?
Connect your passive or active bass here. Adjust GAIN if signal is too hot.
Adjusts incoming signal level for optimal preamp performance. Affects distortion.
Controls the amount of harmonically rich preamp distortion when OVERDRIVE is engaged.
Engages the OVERDRIVE circuit and its corresponding controls.
Adjusts the overall tone of the amplifier.
Controls the overall volume and affects compression/sustain.
Connect speaker cabinets here. Ensure minimum 4Ω impedance.
Power requirement, output, and speaker details for the Rumble 500.
Power requirement, output, and speaker details for the Rumble 500 Head.
Connect your passive or active bass here. Adjust GAIN if signal is too hot.
Adjusts incoming signal level for optimal preamp performance. Affects distortion.
Controls the amount of harmonically rich preamp distortion when OVERDRIVE is engaged.
Engages the OVERDRIVE circuit and its corresponding controls.
Adjusts the overall tone of the amplifier.
Controls the overall volume and affects compression/sustain.
Connect speaker cabinets here. Ensure minimum 4Ω impedance.
Power requirement, output, and speaker details for the Rumble 500.
Power requirement, output, and speaker details for the Rumble 500 Head.
General| Power Output | 100 Watts |
|---|---|
| Effects | Overdrive |
| Cabinet Material | Lightweight Plywood |
| Weight | 22 lbs (9.97 kg) |
| Speaker | 12" Eminence Speaker |
| Inputs | 1 x 1/4" (instrument) |
| Outputs | 1 x XLR (line out) |
| Controls | Gain, Overdrive, Volume, Bass, Mid, Treble, Contour, Bright Switch |
| Auxiliary Input | 1 x 1/8" |
| Dimensions | 16.5 x 16.5 x 14.4 inches (419 x 419 x 365 mm) |
To Next Page