Need help?Do you have a question about the Fender Rumble 40 (V3) and is the answer not in the manual?
Connect your bass guitar here. Adjust GAIN to optimize signal level.
Adjusts incoming signal level, affecting distortion/compression with VINTAGE/OVERDRIVE.
Adjusts overall tone using Bass, Low Mid, Hi Mid, and Treble controls.
Controls overall amplifier volume and sustain via Delta-Comp limiter.
Turns the amplifier unit on or off.
Connects external speaker cabinets with minimum 4Ω impedance.
Connect your bass guitar here. Adjust GAIN to optimize signal level.
Adjusts incoming signal level, affecting distortion/compression with VINTAGE/OVERDRIVE.
Adjusts overall tone using Bass, Low Mid, Hi Mid, and Treble controls.
Controls overall amplifier volume and sustain via Delta-Comp limiter.
Turns the amplifier unit on or off.
Connects external speaker cabinets with minimum 4Ω impedance.
General| Type | Bass Combo Amplifier |
|---|---|
| Power | 40 Watts |
| Channels | 1 |
| Overdrive | Yes |
| Contour | Yes |
| Bright | Yes |
| Mid Scoop | Yes |
| Tuner Output | No |
| Speaker | 10” Fender Special Design Speaker |
| Inputs | 1 x 1/4" |
| Controls | Gain, Bass, Mid, Treble, Volume, Contour, Bright |
| Line Out | Yes |
| Outputs | 1 x XLR Line Out |
| EQ | 3-Band (Bass, Mid, Treble) |
To Next Page